Creating An Ethernet (Lan) Connection - SolarEdge SE12.5K Installation Manual

66

Creating an Ethernet (LAN) Connection

CAUTION!
When removing the cover, make sure not to damage internal components.
SolarEdge will not be held responsible for any components damaged as a
result of incautious cover removal.
Creating an Ethernet (LAN) Connection
This communication option enables using an Ethernet connection to connect the
inverter to the monitoring platform through a LAN.
Ethernet cable specifications:
Cable type – a shielded Ethernet cable (Cat5/5E STP) may be used
Maximum distance between the inverter and the router – 100 m/ 330 ft.
NOTE
If using a cable longer than 10 m / 33 ft in areas where there
is a risk of induced voltage surges by lightning, it is
recommend to use external surge protection devices. For
details refer to:
protection.pdf
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.2
http://www.solaredge.com/files/pdfs/lightning_surge_
Figure 32: Example of Ethernet connection