Figure 1-6 Installing Fan Assembly - Digital Equipment 600a Upgrade Manual

The 600 a Upgrade
12. Install fan assembly into the enclosure using the snap fits in the orientation shown in
Figure 1-6. Run the fan cable to the riser card and connect the cable to the fan
connector.
13. Carefully remove the new MLB from its ESD-protected bag and place it onto a static-
free, flat surface.
14. Carefully remove the DIMM modules from their ESD-protected bag.
_________________________ NOTE____________________________
There are three memory banks (J1/J2, J3/J4, and J5/J6) in the system; each bank
consists of two DIMMs; it is suggested that you use bank J5/J6 for this upgrade.
___________________________________________________________
1–8 DIGITAL Personal Workstation 600a Upgrade Guide

Figure 1-6 Installing Fan Assembly

ML014150