Table of Contents
Advertisement
Safety, Regulatory, Warranty
The following applies to a OneVue Sense models T101, T102, A120, A100, E121, E122, E123.
SAFETY PRECAUTIONS
READ THIS DOCUMENT THOROUGHLY BEFORE PERFORMING INSTALLATION OR SERVICE PROCEDURES.
Safety Precautions
• Device is designed for indoor use only and is not weather protected. Operating a device outdoors or in wet areas is an
electrical hazard and may damage the device while nullifying its warranty.
Equipment Precautions
• To avoid possible electric shock or damage, make sure device is not powered during installation or mounting.
• For healthcare facilities, device is not intended for patient use and must not be installed within 6 feet (2 m) of patient
contact.
• Device may be cleaned with a cloth moistened with water or a common disinfectant. Be sure to test any cleaning
solution on a small area before applying solution to entire device.
REGULATORY APPROVALS
Primex models: Sensors (T101, T102, A120, A100, E121, E122, E123), Bell Controller (E130)
FCC Compliance
Pursuant to FCC 15.21 of the FCC rules, changes not expressly approved by Primex might cause harmful interference
and void the FCC authorization to operate this product.
FCC Radio Frequency Interference
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver's antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Page 20
Advertisement
Table of Contents
