Winding The Lower Thread - Toyota 4500 EL Manual

Winding the Lower Thread
(1) Switch on.
(2) Push in the hand wheel and put
the bobbin onto the spindle.
If you switch on the machine
with the hand wheel in, three
lights; 7
(red), '7 (green) and
0 (green), may flash.
Please switch off and pull out
the hand wheel.
Then start again in the order
(1) and (2).
(3) Pull out the spool pin on the top
of the machine and place a spool
of thread on it.
(4) Lead the thread from the spool pin
through the thread guide to the
bobbin, When you guide the thread
to the guide groove
A
,
make
sure to push the thread well into
the guide spring
B,
by holding
the thread with the tip of your
finger.
(5) Wind the thread around the bob
bin,
counter-clockwise, several
times.
(6) Press the foot controller to wind
the bobbin, checking carefully the
amount of thread wound.
Stop pressing the foot controller
. when the thread reaches the outer
circle on the bobbin.
*
There are three choices of speed to
wind thread (see p. 11).
*
You can not use the tacking button
for winding the lower thread.
correct incorrect
PULL OUT THE HAND WHEEL WHEN
BOBBIN WINDING IS COMPLETED.
6