Changing Presser Foot; Changing Needle - Toyota 4500 EL Manual

Changing Presser Foot
(1) Pull the lever
(A,
towards you so
that the presser foot will come off.
(2) Centre the bar 'B) of the new
presser foot under the shank.
(3) Lower the presser foot lifer so
that the shank fits over the bar.
l
If the shank does not fit well,
pull the lever towards you.
Changing Needle
(1) Push the lower thread pick-up
button to bring the needle to its
highest position.
-^
G Loosen the screw and take out
the needle.
tighten
(2) Insert the new needle, flat side
away from you, as far as it will
go.
(3) Tighten the screw firmly.
Place the needle on a flat surface to
check if it straight.
Do not use needles that are blunt,
rough, dirty, or damaged in any way.
x c 1' |-
x
x
1
17