Reverse Sewing; Thread Cutter - Toyota 4500 EL Manual

Reverse Sewing
Reverse sewing at the end of stitching
is to prevent the thread end from
fraying.
(1) Place the material under the foot
about 1.3cm(1/2") in from the
edge.
(2) Lower the needle and presser foot.
1.3cmil/2")
Leave the ends of the threads
about 15cm(6") long.
(3) Push the reverse button, the
stitches will then be in reverse.
The length of a reverse stitch is
Reverse button
at most O.2cm(1/16'T.
Thread Cutter
At the end of sewing, raise the needle
to its highest position by one push of
the lower thread pick-up button.
Lift the foot and remove the material
by pulling it towards the left.
*Never pull the thread too hard as
it may cause the needle to bend.
Cut both threads together with the
thread cutter
A,'
14