Table of Contents
Advertisement
USE AND ADJUSTMENT
The following values for each single unit can be visualized with
POS.
1
2
3
4
5
If PWM = 100%, it corresponds to 99 on the display. E.g. fig. with 66%.
6
Flowmeter contact open and closed (e.g. fig. contact open then contact closed)
Circulator or motor-driven valve individual unit on/off.
7
Maximum ionization current (range from 0 to 99) at first attempt.
8
E.g. fig. Maximum ionization current value on display 80.
Hours worked by unit (from 0 to 9999 hours)
9
E.g. fig. 8050 hours: first thousands and hundreds then tens and units will ap-
pear in succession and coupled on the display
8.6 Installer programming mode
The installer parameters can be changed by entering the password (22).
The installer level password makes it possible to view and change the user and installer parameters.
Procedure for accessing the programming mode:
POS.
1
2
Press "Set/esc" and "OK" . After 5s, the second and third digits will flash
Use
3
4
Use
5
Press "OK" to confirm the password, if the password is incorrect, the card returns to the Display
6
Press
7
Now P-XX and the respective value will be shown alternatively on the display.
8
Each time a button is pressed, the alternating display of the parameter and the respective value
9
To exit the installer programming mode, press the "Set/esc" button.
See the chapter "Parameter list" for a complete list of the parameters.
DIMENSIONS
Flow temperature (e.g. 70° C)
Return temperature (e.g. 50° C)
Exhaust flue temperature (e.g. 60° C)
Ionization current (index from 0 to 99).
E.g. fig. Ionization current index 44.
Fan PWM signal (%).
(e.g. fig. circulator on then circulator off)
PROCEDURE
Manifold delivery temperature T1
(e.g. T1 = 80°C)
and
to enter the second number of the password (the right digit).
E.g: password = X2
Press "OK" to save the second number of the password
and
to enter the first number of the password (the central digit).
E.g: password = 22
mode. If it is correct, the first parameter P06 is displayed
and
to scroll the parameters enabled by the password.
Press "Set/esc" to start to modify the parameters.
Press
and
to change the parameter value.
stops for 5 seconds and only the value is displayed.
Press "OK" to save the new parameter value.
:
20
DISPLAY
DISPLAY
Advertisement
Table of Contents
