Philips HF3330/01 User Manual page 17

using the appliance
1 Press the on/off button briefly to switch on the appliance (Fig. 8).
The touchscreen display goes on.
,
Note: If you do not touch the display or press any button for 5 minutes when
the display is switched on and the appliance operates on battery power, the
appliance switches off automatically to save battery power.
Note: If you want to switch off the appliance, press and hold the on/off
button for 2 seconds.
2 Briefly press the on/off button again to switch on the LED panel.
The timer counts down the set time.
,
Note: The default treatment time is 15 minutes. Use the timer to change the
treatment time (see section 'Setting the timer' in chapter 'Preparing for use').
When the countdown is finished, the LED panel switches off
,
automatically.
Note: If you want to switch off the LED panel before the countdown is
finished, press the on/off button briefly.
3 Press the plus or the minus button to change the light
intensity (Fig. 11).
You can increase or decrease the intensity in increments of 25%.
Pausing a session
1 Press the on/off button or press the minus button to reduce the
intensity to 0%.
The remaining minutes of the session are still shown on the display.
,
2 Press the on/off button to continue the session or press any of the
touchscreen buttons to end the session.
Note: If you pause a session while the appliance operates on battery power
and do not continue the session within 5 minutes, the appliance switches off
automatically.
setting the alarm
The alarm has three modes: chime only, light only or both chime and light.
4222.002.7541.3.indd 17
EnglisH
17
03-05-10 16:55