Philips HF3330/01 User Manual page 14

EnglisH
14
Charging
Note: You can also use the appliance while it is charging.
The goLITE BLU energy light comes with a 9.5V AC/DC adapter
that operates on voltages ranging from 100 to 240 volts to allow
worldwide use. The adapter comes with a set of exchangeable adapter
plugs that fit most common worldwide wall sockets.
1 Put the adapter in the wall socket.
2 Insert the appliance plug into socket on the appliance (Fig. 4).
Only the outline of the charge indication is visible.
,
As the battery charges, the four bars of the charge indication flash
,
one by one and fill as the charge increases.
When the battery is fully charged, the charge indication stops
,
flashing.
Note: Charge the goLITE BLU energy light at least 8 hours before you use it
for the first time. Charging normally takes 3 to 4 hours.
Note: When the battery is fully charged, it contains enough energy for 3 to 5
treatments.
installation
1 Remove the stand from the stand storage cavity (Fig. 5).
2 Insert the bevelled end of the stand into the hole on the back of
the appliance. Magnets hold the stand in place (Fig. 6).
3 Place the goLITE BLU energy light approximately 50-75cm from
your eyes in such a way that the light bathes your face from the
side (Fig. 7).
- You can read, eat, work at the computer, watch TV or exercise while
you use your goLITE BLU energy light.
- For the best results, place the goLITE BLU energy light at the same
level as your midriff (stomach area), e.g. place it on the table at which
you are sitting.
Note: Do not stare into the light of the LED panel. It is sufficient that the blue
light reaches your eyes indirectly from the side.
4222.002.7541.3.indd 14 03-05-10 16:55