Appendix; Troubleshooting; Control Command - Panasonic ET-MDNFB10 Operating Instructions Manual

Appendix

Troubleshooting

Review the following points.
Problems
The OPT input image is not
displayed.
Cannot switch to the input
of the Interface Board.
Attention
f If problems persist even after checking the preceding points, consult your dealer.

Control command

The following table describes a command to switch to the input of this Interface Board installed on the projector
from a computer.
Command Details
Switching the input
IIS
signal
*1 This can be used when this Interface Board is installed in <SLOT 1> or <SLOT>.
*2 This can be used when this Interface Board is installed in <SLOT 2>.
f Is the SFP module installed correctly?
f Is the optical fiber cable connected correctly?
f Is a signal not supported by this Interface Board or the SFP module input?
f Is there dust or dirt on the connector of the SFP module or the optical fiber cable?
f Is the Interface Board correctly installed in the slot?
Parameter
AU1,OP1
*1
AU1,OP2
*1
AU2,OP1
*2
AU2,OP2
*2
Appendix
Points to be checked
SDI OPT1 [SLOT1], SDI OPT1 [SLOT]
SDI OPT2 [SLOT1], SDI OPT2 [SLOT]
SDI OPT1 [SLOT2]
SDI OPT2 [SLOT2]
Remark
ENGLISH - 21