Programming terminal support system, line converter (18 pages)
Summary of Contents for Panasonic ET-MDN12G10C
Page 1
Interface Board for 12G-SDI Commercial Use ET-MDN12G10C Model No. Thank you for purchasing this Panasonic product. ■ Before using this product, please read these “Operating Instructions” and the “Operating Instructions” of the projector carefully and save the manuals for future use.
Contents Contents Read this first! Precautions for use Supported projector About the handling of the product Disposal Accessories Part names and functions Installing the Interface Board Before installing or removing the Interface Board How to install the Interface Board How to remove the Interface Board Specifications 2 - ENGLISH...
Read this first! Read this first! WARNING: Do not spill water on this product or allow this product to get wet. Doing so may cause fire, electric shock, or malfunction due to short circuit or overheating. f Do not place a container with liquid close to this product. f Consult your dealer when liquid such as water is spilled on this product.
Page 4
Read this first! Name and quantity of hazardous substances contained in the product Hazardous substances Parts Cr VI PBB PBDE Printed circuit boards (PCB) Accessories This table is prepared in accordance with the provisions of SJ/T 11364. : The amount of hazardous substances included in all homogeneous materials for the relevant part does not exceed the limit specified in GB/T 26572.
Precautions for use Precautions for use This product is a 12G-SDI signal compatible interface board for use installed in a Panasonic projector. Supported projector PT-SRQ32KC, PT-SRQ13KC, PT-SRQ22KC (As of March 2019) Note f Products other than the above may also be supported. Check the Operating Instructions of your projector.
Precautions for use Note f The supplied screws are spare. Use them when a screw to fix the slot cover of the projector is lost. f The model numbers of accessories are subject to change without prior notice. Part names and functions <SDI 1 输入>...
Installing the Interface Board Installing the Interface Board It is recommended to ask a qualified technician to install or remove the Interface Board to a projector. A malfunction may occur due to static electricity. Consult your dealer. Before installing or removing the Interface Board f Always turn off the power of the projector before installing or removing the Interface Board.
Installing the Interface Board How to install the Interface Board Screws (4 locations) Screws (4 locations) Salient Guide groove Slot cover Fig. 1 Fig. 2 Fig. 3 Remove the slot cover. (Fig. 1) f Remove the four screws fixing the slot cover of the projector by rotating counterclockwise with a Phillips screwdriver.
Installing the Interface Board How to remove the Interface Board Handle Fig. 1 Remove the Interface Board. (Fig. 1) f Remove the four screws fixing the Interface Board by rotating counterclockwise with a Phillips screwdriver. The removed screws are used to fix the slot cover. f Hold the handle of the Interface Board and remove it slowly.
Specifications Specifications Compatible slot SLOT NX specification BNC 4 lines (<SDI 1 输入> terminal, <SDI 2 输入/1 输出> terminal, <SDI 3 输 入> terminal, <SDI 4 输入/3 输出> terminal) Single link SD-SDI signal, SMPTE ST 259 standard compliant Single link HD-SDI signal, SMPTE ST 292 standard compliant Single link 3G-SDI signal, SMPTE ST 424 and 425-2 standards compliant Single link 6G-SDI signal, SMPTE ST 2081-1 and 2081-10...
Page 11
Specifications Note f “SLOT NX” is a name of the slot unique to Panasonic supporting the signal input for the 4K image. f The video signal that can actually display will vary depending on the projector that the Interface Board is installed. For details, refer to the Operating Instructions of your projector.