Filling The Jacket - Bertos E7PI Instruction Manual

Warning! : The water level in the jacket must be checked each time before lighting.
Warning! : It is advisable to use softened water to fill the jacket!
 Open the level tap on the front of the appliance.
 Unscrew the filling cap on the safety valve unit. The latter is on the right of the
appliance surface (see figure "Size of appliance and position of connections ").
 Fill with softened water (the capacity of the jacket is stated in the paragraph "Technical
data").
 When water flows out of the level tap, close it and screw back on the safety unit cap.
3.2.2. SWITCHING ON, START COOKING AND
 Fill the vat with hot or cold water, according to need, using the tap that the appliance is
equipped with.
 The appliance has a three-position selector to start cooking functions (see figure
"Controls").
 Here is a list of the procedures for a safe and correct use of the appliance.
Energising the unit:
 Connect the appliance by turning on the main switch installed before it.
Start of cooking:
 Turn the selector from position "0" to one of the heating positions according to cooking
requirements.
 The green light turns on automatically.
 Generally cooking is started with the selector in position "2"; once the vat has reached
cooking temperature, turn the selector to "1" to maintain it.
 Set the operating thermostat knob on the desired temperature between 40 and 100°C.
 Heating will start and the orange light will turn on automatically.
 The orange light will turn off as soon as the set temperature has been reached.
 To make water boil quickly, turn the knob over the temperature of 100°C.
 Heating elements operate continuously.
 By turning the selector from position "2" to "1", it is possible to keep the water boiling
and use less power.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Pentole elettriche E7PI

3.2.1. FILLING THE JACKET

SWITCHING OFF
07.04.01 - IT pagina 48