Table of Contents
Advertisement
Installation and Removal
1
1-18
3. Carefully remove the host module from its card slot and place it on
a clean and adequately protected working surface (preferably an
ESD mat) with the secondary side of the board facing up.
4. Remove the four screws from the holes in the host board that fasten
the Gigabit Ethernet/82543 PMC Module module to the host board.
5. Carefully turn the host board to the primary side and place on your
working surface. Gently separate the Gigabit Ethernet/82543 PMC
Module from the PMC connectors on the host board. Do not damage
or bend connector pins.
6. Tilt the board up slightly and remove it from the front panel slot.
Gigabit Ethernet/82543 PMC Installation and Use
Advertisement
Table of Contents
