Assembling The Server Rack - StarTech.com RK1836BKF User Manual

Assembling the Server Rack

Align the Screw Holes on the corners of the Side Panel with
1.
the Screw Holes on the ends of the Center Beam. Ensure
that the Lip on the Center Beams lines up with the Lip on
the inner side of the Side Panel.
Slide an M8 Spring Washer over the M8 x 20 mm Hex
2.
Screw.
Insert the M8 x 20 mm Hex Screws through the Screw Hole
3.
on the Side Panel and into the Screw Holes on the Center
Beam.
Using the M8 Hex Key tighten the M8 x 20 mm Hex Screws,
4.
being careful not to over-tighten.
Repeat steps 1 - 4 to install the other Side Panel and the
5.
remaining Center Beams.
Turn the Server Rack upside down, resting the Server Rack
6.
on it's top.
Align the Mounting Holes on the Casters with the
7.
Mounting Holes in the corner of the Server Rack Frame.
Insert an M6 x 10 mm Screw through the Mounting Hole
8.
on the Caster and into the Mounting Hole on the Server
Rack Frame.
Using a Phillips Head Screwdriver, tighten the M6 x 10 mm
9.
Screw, being careful not to over-tighten.
Repeat steps 1 - 4 to install the other Caster and Casters
10.
with Brakes.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
15