Processors And Heat Sinks; Removing A Heat Sink - Dell DSS 1510 Owner's Manual

5. remote management port card connector on the system board
Next steps
1. If removed, reinstall the PCIe expansion card riser.
2. If disconnected, connect the cables to the expansion card(s).
3. Reinstall the cooling shroud.
4. If required, open the expansion card latch on the cooling shroud to secure the full length expansion card.
5. Follow the procedure listed in the After working inside your system section.
Related tasks
Before working inside your system
Removing the cooling shroud
Removing the expansion card riser
Installing the expansion card riser
Installing the cooling shroud
After working inside your system
Removing the optional remote management port card
Related reference
Safety instructions

Processors and heat sinks

NOTE: For the 140 W heat sink, the larger part of the heat sink should be fixed on CPU1 and the smaller part on CPU2.
Use the following procedure when:
• Removing and installing a heat sink
• Installing an additional processor
• Replacing a processor
Table 31. Processor wattage and heat sink dimensions
Processor
Up to 135 W (Intel Xeon E5 2600 v3 or v4
product family processors)
140 W (Intel Xeon E5-1600 v3 or v4 product
family processors)

Removing a heat sink

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is
necessary to maintain proper thermal conditions.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell
certified service technicians.
Heat sink (dimensions)
84 mm x 106 mm x 22.7 mm
84 mm x 106 mm x 28.7 mm
81 mm x 99 mm x 28.7 mm
Installing and removing system components
Heat sink
Heat sink type
single heat sink
dual heat sink
85