Table of Contents
Advertisement
PRECAUTIONS REGARDING WARRANTY AND
SPECIFICATIONS
This product is designed and manufactured by Cognex Corporation. Note that the warranty and general specifications of this
product differ from that of programmable controller products.
• Warranty
Item
Free warranty period
Repair period after discontinuation of
manufacture
• General specifications
Item
Specifications
Ambient operating
0 to 40
temperature
Ambient storage
-10 to 60
temperature
Maximum humidity
Less than 95% RH, non-condensing
Vibration resistance
IEC 60068-2-6: A vibration of 10 G
(10 to 500 Hz at 100 m/ with 15 mm
width) was applied to each X, Y, and
Z direction for 2 hours.
Shock resistance
IEC 60068-2-27: 1000 half
sinusoidal shocks with 11 G in 10 ms
were applied.
Operating
There is no danger of corrosive
atmosphere
gases, flammable gases, and strong
alkaline substances to adhere.
Protective structure
IP65 (when all connectors are
attached to cables or shielded by a
sealing cap)
Installation location
Outside a control panel
CE
This section describes a summary of precautions when bringing into CE conformance the machinery formed by using the
vision sensor.
Note that the descriptive content is material created based on regulation requirements and standards obtained by Mitsubishi
Electric Corporation. However, machinery manufactured in accordance with this content is not necessarily guaranteed to
conform with the above commands.
Final judgment regarding CE conformance or the method of conformance must be the judgment of the machinery
manufacturer itself.
To meet the CE compliant conditions, implement the following items.
• Significant amount of noise on the power source may cause malfunction. Use a regulated DC power supply with an
isolating transformer for the power supply. Additionally, install a noise filter (SNR-10-223 by COSEL or an equivalent
product) between the vision sensor and the regulated DC power supply.
Vision sensor
18 months after delivery or 24 months
after manufacture
7 years
Programmable controller product (Example: MELSEC iQ-R series)
0 to 55 (when a base unit other than an extended temperature range base unit is used)
0 to 60 (when an extended temperature range base unit is used)
-25 to 75
5 to 95% RH, non-condensing
Compliant
with JIS B
3502 and IEC
61131-2
Compliant with JIS B 3502 and IEC 61131-2 (147m/, 3 times each in X, Y, and Z bidirections)
No corrosive gases, flammable gases, less conductive dust
Inside a control panel
Programmable controller product (Example: MELSEC iQ-R
series)
36 months after delivery or 42 months after manufacture
7 years
Frequency
Constant
acceleration
Under
5 to 8.4 Hz
intermittent
8.4 to 150
9.8 m/
vibration
Hz
Under
5 to 8.4 Hz
continuous
8.4 to 150
4.9 m/
vibration
Hz
Half
Sweep count
amplitude
3.5 mm
10 times each
in X, Y, and Z
directions
1.75 mm
1
Advertisement
Table of Contents
