Table of Contents
Advertisement
3
SPECIFICATIONS
This chapter shows the specifications of vision sensor VS20s.
3.1
General Specifications
The following shows the general specifications of vision sensor VS20s.
Item
Ambient operating temperature
Ambient storage temperature
Maximum humidity
Vibration resistance
Shock resistance
Operating atmosphere
Protective structure
*1
Installation location
*1 Do not install it in the following places:
⋅ Where the ambient temperature or humidity exceed the applicable ranges
⋅ Where condensation occurs due to sudden temperature changes
⋅ Where there is corrosive or flammable gas
⋅ Where there are a lot of conductible dust, iron filings, or salt
⋅ Where in danger of organic solvents, such as benzene, thinner, and alcohol or strong alkaline substances such as caustic soda to
adhere
⋅ Where subject to much vibration or shock
⋅ Where in danger of liquid such as water, oil, or chemicals to adhere
Specifications
0 to 40
-10 to 60
Less than 95% RH, non-condensing
IEC 60068-2-6: A vibration of 10 G (10 to 500 Hz at 100 m/ with 15 mm width) was applied to each X, Y, and Z
direction for 2 hours.
IEC 60068-2-27: 1000 half sinusoidal shocks with 11 G in 10 ms were applied.
There is no danger of corrosive gases, flammable gases, and strong alkaline substances to adhere.
IP65 (when all connectors are attached to cables or shielded by a sealing cap)
Outside a control panel
3 SPECIFICATIONS
3.1 General Specifications
3
15
Advertisement
Table of Contents
