Programming Menu And Instructions; Energy Saving Sleep Mode - WaterLogic CUBE Manual

PROGRAMMING: ENERGY SAVING SLEEP MODE
The Waterlogic CUBE Water Treatment System has an Energy Saving Sleep Mode feature that
minimizes power consumption by shutting down the heater circuit if the machine has not been
operated for either 3 or 72 hours depending on the program setting. The CUBE is shipped with
default set to 3‐hour Energy Saving Sleep Mode.
1. Default is set to 3 hours.
Press and hold Hot Water Icon for 10
seconds, until you hear the CUBE
beep.
2. To set Energy Saving Sleep Mode to 72
hours, press and hold the Extra Hot
water icon for 10 seconds, until you
hear the CUBE beep.
3. Once the Cube is in Energy Saving
Sleep Mode.
The white LED light surrounding the
dispense buttons illuminates.
4. To wake up the CUBE out of Energy
Saving Sleep Mode, touch the Hot LED
Icon shown.
Note: Hot water may take up to 10‐12
minutes to reach Hot Water
Temperature after waking up out of
Energy Saving Sleep Mode.
CUBE Manual
PROGRAMMING MENU AND INSTRUCTIONS
Page 36 – Revision 10‐8‐2018
Hot Water Icon
Extra Hot Water Icon
White LED light
around Dispense
Button
Hot Water Icon