Operation - Vacmaster VDK1538SWC Original Instructions Manual

GB
holder. Pry the attachment up from underneath (Fig. 10 & 11).
3) Insert the new attachments into the holder applying downwards pressure (Fig. 11).
4) The attachments can be used in three combinations (Fig. 12):
Brush and Squeegee Combination: For use with mixture of wet or dry liquids.
Dual Brush Combination: For use with dry materials or carpeted floor surfaces.
Dual Squeegee Combination: For use on hard floor with wet liquids
NOTE: The textured side of the rubber squeegee must be facing outwards.
1. Switching On/Off
Connect the mains plug to a suitable power outlet.
Position
I
O
II
2. Power Tool Take-Off Operation (Fig. 13)
WARNING: Always check the maximum wattage compatibility of the power tool take off
socket against the desired power tool before connecting to prevent overloading.
1) Connect the power cable of your power tool to the power take-off socket.
2) If applicable, connect the vacuum suction hose to the dust extractor connector on your tool with
the supplied adaptor.
3) Switch the vacuum cleaner to position II, as described in Switching ON/OFF. The moment you
switch on the power tool, the vacuum cleaner will also switch on. Once the electrical appliance
has been switched off, the vacuum cleaner switches off following a time lapse (around 5
seconds) to allow the suction tube to be emptied.
3. Power Regulator
The airflow can be continuously adjusted by turning the power regulator (Fig. 14).
MIN:
Reduced suction for applications which generate a low level of dust.
MAX:
Maximum suction performance for use in applications which generate a high level of dust.
4. Filter Cleaning Operation
IMPORANT: Only perform the filter cleaning operation when the cartridge filter is
installed.
After continuous dry vacuuming operation, air flow will decrease due to heavy accumulation of
material and debris on the cartridge filter. This vacuum is equipped with integrated filter cleaning to
increase dust collection efficiency.
When reduction of air flow (≤20m/s) has occurred during operation, the air flow indicator next to the

OPERATION

Status
on
off
automatic synchronized start-up
12