TP-Link JetStream TL-SL3452 Reference Manual page 130

Gzcorng"
Configure the Duplex Mode as full-duplex for Gigabit Ethernet port 25:
VN/UN564:*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25
VN/UN564:*eqphki/kh+%fwrngz full"
urggf"
Fguetkrvkqp"
The"urggf"command is used to configure the Speed Mode for an Ethernet port.
To return to the default configuration, please use pq"urggf"command."
U{pvcz"
urggf { 10 | 100 | 1000 | auto }"
pq"urggf"
Rctcogvgt
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are four
options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode (default).
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Configure the Speed Mode as 100Mbps for Gigabit Ethernet port 25:
VN/UN564:*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25
VN/UN564:*eqphki/kh+%urggf 100"
uvqto/eqpvtqn"dtqcfecuv"
Fguetkrvkqp"
The" uvqto/eqpvtqn" dtqcfecuv" command is used to enable the broadcast
control function. To disable the broadcast control function, please use pq"
uvqto/eqpvtqn" dtqcfecuv" command. Broadcast control function allows the
switch to filter broadcast in the network. If the transmission rate of the broadcast
packets exceeds the set bandwidth in the uvqto/eqpvqtn"tcvg, the packets will
be automatically discarded to avoid network broadcast storm.
U{pvcz"
VN/UN564:1VN/UN5674
118
LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg