Table of Contents
Advertisement
G
ETTING STARTED
3.4 The Transmitter (Tx)
1. Accessory connector sockets
These sockets are used to create a
direct galvanic connection to the target
line or to create a connection using a
special connection set (e.g. transmitter
clamp or house connection set - see
"Spare parts and optional accessories"
on page 28).
2. Battery status indicator
When the battery status indicator is
red, the batteries need to be replaced.
3. On/Off button
Press and hold to switch on. Press
again to switch off.
All appropriate LEDs blink when the
transmitter is on, depending on operating function.
c
4. Control buttons
Button M
• Switches between
continuous and pulsed
signal output
c.
The function of buttons M, P and C depends upon the status of the system
6
R
Button P
• Switches between signal
power levels (0.1 W or
0.5 W)
1
2
3
4
Button C
• Switches between inductive
and direct signal coupling
Advertisement
Table of Contents
