Table of Contents
Advertisement
T
-
,
RANSMITTER
USE
4 TRANSMITTER - USE, SETUP AND SIGNAL COUPLING
4.1 Using the transmitter
Follow the steps listed below in order to prepare the transmitter to search for lines in conjunction
with the receiver:
Step Action
1.
Decide whether the transmitter signal is going to be coupled to the line by induction
or by direct connection.
•
If coupling by induction, place the transmitter on the site to be searched.
•
If coupling directly, connect the transmitter to the line to be located by the most
suitable method.
2.
Switch on the transmitter.
3.
Select the desired signal characteristics using the P and M buttons.
A green LED indicates that the respective setting is active.
4.
Select the desired operating mode using the C button.
In direct mode, an LED next to the
connection to the line is:
•
Green blinking: good (low-resistance) connection
•
Alternating red and green: sufficient connection
•
Red blinking: poor/no (high-resistance) connection
Your transmitter is now set up and transmitting signals. Now you can use the receiver to locate
metallic conductors - see "Receiver - use, adjusting sensitivity and setup" on page 16.
8
R
SETUP AND SIGNAL COUPLING
symbol indicates how good the
Page
10-15
14
10-15
6
9
9
Advertisement
Table of Contents
