Table of Contents
Advertisement
5.3.2 To select depth measurement type and units:
Step Action
1.
Switch off the receiver.
2.
Press and hold button # 1.
3.
While continuing to hold button # 1, press and release the power on/off button.
The instrument will switch on and then beep.
4.
Release button # 1.
The screen displays:
5.
If required, to adjust the depth measurement type, press button # 1:
•
= depth measurement using a Probe (optional accessory - see page 28)
•
= depth measurement without a Probe (normal method)
6.
If required, to adjust the depth measurement units, press button # 3:
•
= feet and inches
•
= metres
7.
Press button # 2 [OK] to save the settings.
The changes will remain in effect even after the receiver is switched off and back on again.
5.3.3 To select receiver power grid mode detection frequency (50 Hz/60 Hz):
Step Action
1.
Switch on the receiver and press button # 3 until the instrument is in Power Grid mode
[
].
2.
Switch the instrument off.
3.
Press and hold button # 3.
4.
While continuing to hold button # 3, press and release the power on/off button.
The instrument will switch on and then beep.
5.
Release button # 3.
6.
Press button # 1 to select 50 Hz operation or button # 3 to select 60 Hz operation.
7.
Press button # 2 [OK] to save the settings.
The changes will remain in effect even after the receiver is switched off and back on again.
R
-
,
ECEIVER
USE
ADJUSTING SENSITIVITY AND SETUP
R
19
Advertisement
Table of Contents
