System Board - HP EliteDesk 705 G5 Maintenance And Service Manual

System board

NOTE: All system board spare part kits include replacement thermal material.
1. Prepare the computer for disassembly
2. Remove the access panel
3. In models with a hard drive, remove the hard drive
on page
4. In models with a discrete graphics processor, remove the graphics processor and heat sink assembly
(Graphics processor and heat sink assembly on page
5. Remove the fan
6. Remove the heat sink
7. When replacing the system board, remove the following components from the defective system board
and install them on the replacement system board (as applicable):
Memory modules
●
M.2 solid-state drive
●
Processor
●
WLAN module
●
Expansion connector board
●
8. To remove the system board:
a. On models with a hard drive, disconnect the speaker cable from the system board (1), and then
remove the three Torx T15 screws (2) that secure the system board to the computer.
(Access panel on page
29.
(Fan on page 41).
(Heat sink on page
(Memory modules on page
(M.2 PCIe solid state drive (SSD) on page
(Processor on page
(WLAN module on page
(Preparation for disassembly on page
23).
(Hard drive on page
30).
42).
38)
44)
33)
(Expansion connector board on page
22).
27) and drive cage Drive cage
31)
37)
System board 45