HP EliteDesk 705 G5 Maintenance And Service Manual page 69

Table 5-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
●
●
●
●
●
●
●
●
●
HP Sure Recover HP Sure Recover
Enable to cause system firmware to honor local and remote requests to install the operating system.
Recover from Network
Enable to cause system firmware to get the recovery agent from the network. Disable to cause firmware
to get the agent from a local drive.
Recover after Boot Failure
If enabled and no bootable UEFI operating system is found, system firmware launches HP Sure Recover.
Secure Boot Configure Legacy Support and Secure Boot
Configuration
Lets you turn off all legacy support on the computer, including booting to DOS, running legacy graphics
cards, booting to legacy devices, and so on.
Lets you be sure an operating system is legitimate before booting to it, making Windows resistant to
malicious modification from preboot to full OS booting, preventing firmware attacks. UEFI and Windows
Secure Boot only allow code signed by pre-approved digital certificates to run during the firmware and OS
boot process.
●
●
●
Default is Legacy Support Disable and Secure Boot Disable.
Secure Boot Key Management
Lets you manage the custom key settings.
CD-ROM Boot. Default is enabled.
USB Storage Boot. Default is enabled.
Network (PXE) Boot. Default is enabled.
After Power Loss. Default is Power Off.
■ Power off—causes the computer to remain powered off when power is restored.
■ Power on—causes the computer to power on automatically as soon as power is restored.
Previous state—causes the computer to power on automatically as soon as power is restored,
■
if it was on when power was lost.
NOTE: If the system is configured to Power On from Keyboard Ports (see Power Management
Options), then this setting is forced to Power On.
Audio Alerts During Boot. Default is enabled. When disabled, most audible beeps from errors,
warnings, and password prompts during boot up are suppressed.
Prompt on Memory Size Change. Default is enabled.
Prompt on Fixed Storage Change. Default is disabled.
NumLock on at boot. Default is disabled.
UEFI Boot Order.
Default is enabled. Specify the order in which UEFI boot sources (such as a internal hard drive, USB
hard drive, USB optical drive, or internal optical drive) are checked for a bootable operating system
image.
UEFI boot sources always have precedence over legacy boot sources.
Legacy Support Enable and Secure Boot Disable
Legacy Support Disable and Secure Boot Enable
Legacy Support Disable and Secure Boot Disable
Computer Setup (F10) Utilities 59