HP EliteDesk 705 G5 Maintenance And Service Manual page 96

NOTE: The memory count will be affected by configurations with the Management Engine (ME) enabled. The
ME uses 8 MB of system memory in single channel mode or 16MB of memory in dual-channel mode to
download, decompress, and execute the ME firmware for Out-of-Band (OOB), third-party data storage, and
other management functions.
System will not boot or does not function properly after installing additional memory modules.
Cause
A memory module is not installed in the DIMM1 or XMM1 socket.
Memory module is not the correct type or speed grade for the
system or the new memory module is not seated properly.
Out of memory error.
Cause
You have run out of memory to run the application.
Memory count during POST is wrong.
Cause
The memory modules may not be installed correctly.
Integrated graphics may use system memory.
Insufficient memory error during operation.
Cause
Too many Terminate and Stay Resident programs (TSRs) are
installed.
You have run out of memory for the application.
Power LED flashes red five times, once every second, followed by a 2 s pause, and the computer beeps five times. (Beeps stop
after fifth iteration but LEDs continue flashing.)
Cause
Memory is installed incorrectly or is bad.
86 Chapter 6 Troubleshooting without diagnostics
Solution
Make sure that a memory module is installed in the DIMM1 or
XMM1 socket on the system board. This socket must be populated
with a memory module.
Replace module with the correct industry-standard device for the
computer. On some models, ECC and non-ECC memory modules
cannot be mixed.
Solution
Check the application documentation to determine the memory
requirements.
Solution
Check that the memory modules have been installed correctly and
that proper modules are used.
No action required.
Solution
Delete any TSRs that you do not need.
Check the memory requirements for the application or add more
memory to the computer.
Solution
1. Reseat DIMMs. Power on the system.
2. Replace DIMMs one at a time to isolate the faulty module.
3. Replace third-party memory with HP memory.
4. Replace the system board.