Pedal Calibration - Korg SV-2 User Manual

106| The Editor

Pedal calibration

You can calibrate the pedals connected to the DAMPER, PEDAL 1 and PEDAL
2 connectors in the back panel. By calibrating a pedal, you let the SV­2 un­
derstand its polarity and the full range of values sent.
1 Connect all pedals to be calibrated to the SV­2. Remember that DAMPER
expects the included KORG DS­2H damper pedal (or, as an alternative, the
optional DS­1H, or any footswitch pedal), PEDAL 1 expects a footswitch ped­
al, and PEDAL 2 can be used to connect either a footswitch or a volume/
expression pedal.
2 Set any volume/expression­type pedal to its lowest setting.
3 Go to the Global page, and click the Start button in the Pedal Calibration
section. When the "Are you sure?" message appears, click the Yes button (or
No to cancel the calibration procedure). The Pedal Calibration Mode dialog
appears, and SV­2 enters calibration mode.
4 Now calibrate PEDAL 1 (a footswitch). Completely depress the pedal, then
release it. When you have finished calibrating the pedal connected to the
PEDAL 1 jack, FAVORITES button #1 will turn on.
5 Then, calibrate PEDAL 2. The procedure is different, depending on the use
of a footswitch or a volume/expression pedal:
▪
If you connected a footswitch, completely depress it, then release it.