Making the connections
In this section you will learn how to connect your SV2 to an audio amplifica
tion system, to the pedals and to MIDI devices.
1
Turn both your SV2 and all connected devices off.
NOTE:
You must turn off the power of all your equipment before you make connec
tions. If you ignore this warning, you may damage your speaker system!
2
If you're connecting the SV2 to a mixer or speaker system, connect the
OUTPUT jack(s) to the line input jack(s) of your mixer/recorder or speaker
system.
If you're making connections in mono, use any of the MONO OUTPUT jacks.
However, to take the fullest advantage of the SV2's sound, we strongly rec
ommend that you use stereo connections.
3
If you're listening through headphones, connect your headphones to the
HEADPHONES (
The integrated speakers will automatically turn off. Signal from the OUTPUT
jack(s) will still be heard even if headphones are plugged in. If you only want
to hear signal from headphones you should turn off or lower down any equip
ment the SV2 is connected to.
4
Turn the MASTER VOLUME knob on the front panel of the SV2 all the way
to the left, setting the volume to '0'.
5
Plug the supplied IEC AC power cable into the SV2's rear panel AC power
inlet, and plug the other end into an AC wall socket.
6
Connect the pedals to the relevant PEDAL connectors on the rear panel.
7
Connect the MIDI or USB cable to your SV2 and to the other device.
8
Plug any external CD/audio player or synthesizer into the rear panel INPUT
jacks.
9
Turn on the POWER switch to power up the SV2.
10
Turn on the power switch of your mixer or speaker system.
11
To adjust the volume, turn up the volume controls on your mixer or speakers,
and use the SV2's front panel MASTER VOLUME knob to adjust the volume
to a desired level.
) jack.
Controls and connections |13