METHVEN ROUND RAIL Installation Manual

Elbow Installation (if supplied):
Step 1
• Wall lining hole should be cut or finished as per
the dimension shown in the diagram on the right.
• Cut off the threaded nipple 13±2mm from the wall
lining and apply thread seal tape to ensure a
good seal.
Step 2
•
Screw the elbow onto the nipple ensuring
that the o-ring is sufficiently compressed to
create a watertight seal.
• Ensure that the elbow is oriented vertically
with the outlet oriented downwards.
Care and Cleaning:
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the filter washer should be removed from the end of the shower hose and cleaned.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand Australia
ROUND RAIL
Installation Guide
Technical Specifications:
26mm max
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
UK
ISSUE B
www.methven.com