Post Installation Configuration; System Configuration Overview; Mounting, Wiring, And Power Checks - Garmin GTX 335 w GPS Installation Guidance

Table of Contents

6 POST INSTALLATION CONFIGURATION

6.1

6.2

6.3

GTX 335 Remote Unit Configuration (Wizard Tool) ......................................................................6-2

6.4

GTN 6XX/7XX Configuration with GTX........................................................................................6-2

6.5

GNS 400W/500W Series Configuration...........................................................................................6-3

6.1 System Configuration Overview

This section contains instructions for configuring each installation.

The checkout log contained in Appendix A of GTX 33X and GTX 3X5 ADS-B Maintenance Manual must be

filled out during the checkout procedures. The completed checkout log sheet must be maintained with the

aircraft permanent records to document the configuration of the installation.

6.2 Mounting, Wiring, and Power Checks

CAUTION

Make sure there are no pins misaligned or bent before inserting the GTX into the mounting

rack. Bent or misaligned pins will result in damage to the GTX or failed procedures.

CAUTION

Make sure the wire harness does not touch any moving part.

CAUTION

Make sure all lighting buses are set to their lowest adjustment before the unit is energized.

The lowest adjustment prevents damage to the unit in case of any wiring errors. Incorrect

lighting bus wiring could cause damage to the GTX.

The wiring harness must be examined for correct connections to the aircraft systems and other avionics

equipment before the unit is installed and energized. Point-to-point continuity must be completed to expose

any faults such as shorting to ground or wiring discrepancies. All faults or discrepancies must be corrected

before proceeding.

190-00734-17

Rev. 1

GTX 335 w/GPS Installation Guidance

Page 6-1

Table of Contents

Table of Contents