Gae - Garmin GTX 335 w GPS Installation Guidance

1.4.2

GAE

The GAE module supplies the required barometric altitude source for ADS-B Out compliance. The sensor
module has an orifice that allows the module to be connected to the static system. The GAE attaches to the
rear connector plate with two screws, and has short, unshielded wires to connect to the GTX 335 unit
through the rear D-sub connector with the same connection as the configuration module. The GAE contains
the configuration module. If the GAE is used, a separate configuration module is not required. Refer to
section 4 for installation guidance.
Figure 1-3 GAE
190-00734-17 GTX 335 w/GPS Installation Guidance
Rev. 1 Page 1-10