Figure 4-7 Shielded Wire Preparation; Table 4-4 Shield Wire Assembly - Garmin GTX 335 w GPS Installation Guidance

Refer to
figure 4-7
Multiple conductor shielded cable
1
(Refer to appendix B for interconnect diagrams)
2 Wire, insulated (20-22 AWG), 3" max length
3 Shield terminator
4 Pin contacts, #22D
Ring terminal, #8, insulated, 18-22 AWG,14-16 AWG,
5
12–10 AWG
[1] Item not supplied in connector kits and must be purchased separately.
[2] Solder sleeve with pre-installed lead can be used instead of items 1 and 2.
[3] Not a Garmin part number.
[4] Supplied as part of Sub Assy Connector Kits for GTX 335.
[5] Part not shown in figure 4-7.
0.17"
0.17"
SHIELD DRAINS AS SHORT AS PRACTICAL
190-00734-17
Rev. 1

Table 4-4 Shield Wire Assembly

Description
2.5" MAX
2
SHIELD DRAINS AS SHORT AS PRACTICAL
(NO LONGER THAN 3")
PREFERRED METHOD
2.5" MAX
0.31" OF EXPOSED SHIELD
(NO LONGER THAN 3")
ALTERNATE METHOD

Figure 4-7 Shielded Wire Preparation

Garmin P/N
As required
As required
As required
336-00021-00
MS25036-149
MS25036-153
MS25036-156
3
1
0.31" OF EXPOSED SHIELD
3
1
GTX 335 w/GPS Installation Guidance
Notes
[1] [2]
[1] [2]
[1] [2]
[4] [5]
[1] [2] [3] [5]
2
Page 4-13