Figure 4-11 Configuration Module Assembly; Table 4-7 Configuration Module Kit, P/N 011-00979-03; Configuration Module Installation - Garmin GTX 335 w GPS Installation Guidance

4.4.2

Configuration Module Installation

1. Crimp pin contacts (3) onto each wire of the four-conductor wire harness (2). Strip 0.17" of
insulation from each wire prior to crimping.
2. Insert newly crimped pin contacts and wires (2, 3) into the correct locations in the connector
housing as shown in figure 4-11.
3. Plug the four-conductor wire harness (2) into the connector on the PCB board (1).
4. Insert PCB board (1) into the backshell recess.
5. Orient the connector housing so that the inserted four-conductor wire harness (2) is on the same
side of the backshell, as the inserted PCB board (1), as shown in figure 4-11.

Table 4-7 Configuration Module Kit, P/N 011-00979-03

Item
1 Configuration module, PCB board assembly w/EEPROM
2 4-conductor harness
3 Pin contact, crimp, #22D
190-00734-17
Rev. 1
Description

Figure 4-11 Configuration Module Assembly

P/N
011-02178-00
325-00122-00
336-00021-00
GTX 335 w/GPS Installation Guidance
QTY
1
1
4
Page 4-19