Advertisement
Installation–Stationary Mounting
The typical installation shown in Fig. 2 is only an installation guide; it is not an actual system design. Contact your
Graco distributor for assistance in designing a system to suit your needs.
For Stationary Mountings
B
A
Fig. 2
NOTE: See Fig. 4 on page 8 for the mobile mounting
installation.
Stationary Mounting Layout
Plan the mounting layout for easy operator access to
the pump air controls, sufficient room to change
drums, and a secure mounting platform.
For ease in changing drums, install a pump elevator.
Open-Drum, Cover-Mounted Pumps
1. Remove the original drum cover.
2. Mount and fasten the new drum cover.
3. Guide the pump riser tube through the mounting
gasket.
Closed Bung-Type Drum
1. Loosen the drum cover vent plug, and remove the
bung cover.
2. Install the pump through the bung hole until the
pump foot valve is 1/2 in. (13 mm) off the drum
bottom. Tighten the bung adapter.
6
307883
C
D
E
1/2 in. (13 mm)
J
F
G
H
A Fluid outlet line
B Pump
C Ground wire
D Pump runaway valve
E Air lubricator
F Bleed-type master air valve
G Air regulator
H Air filter
J Main air line
Air and Fluid Line Accessories
Install the accessories in the order shown in Fig. 2.
CAUTION
Do not hang the air accessories directly on the air
inlet. Mount them on brackets. The fittings are not
strong enough to support the accessories and may
break.
D Use thread sealant on male threads except at
swivel connections.
D Install a pump runaway valve (D) to stop the pump
if the fluid supply is depleted.
D Install a bleed-type master air valve (F) upstream
from the pump air regulator (G), but within easy
reach of the pump.
To order a 300 psi (21 bar) maximum working
pressure, 1/2 in. npt bleed-type master air valve,
order Part No. 107142.
01611
Advertisement
