Table of Contents
Advertisement
Note: You can connect the General Engine-Module instead of the receiver directly to the jack on the right
side of the SMART-BOX. By doing this, the settings will be sent directly to the General Engine-Module
(without using the radio control system) and the programming is much faster. A power supply for the SMART-
BOX is neccessary (3.6 - 9 V), inserted on the left side. The connector system is reverse polarised, look
for the small camfer on the edges. Do not use force, the plug should click into place easily. This sockets is
labeled accordingly also. The black wire must be down (-), the red top (+).
5. OPERATION
The operation of the General Engine-Module is similar to the operation of the transmitter. You should also
read the manual of your remote control system, especially the chapter „telemetry". The operation is done in
the transmitter menu „telemetry" under the display SETTING & DATA VIEW. The sensor displays follow the
receiver displays (RX), i.e. the „Lipo Cell Voltage" display follows after the last display servo test (RX SERVO
TEST). Please note: the menus can only be selected when the receiver is switched on. When you switch
the receiver on, it may take a few seconds before the receiver display becomes active and can be selected:
> symbol appears at the top right corner of the transmitter display (TX).
There may be a slight delay in the screen's response to inputs, since all the settings are transmitted directly
to the receiver by wireless means.
Operation with the SMART-BOX:
The SMART-BOX is operated by the four buttons on the top. Switch with the ESC and ENTER keys between
the different displays. With the DEC and INC buttons you can select the parameters in the display (INC
moves the cursor down, DEC up).
Switch on the transmitter. On the startup screen appears SETTING AND DATA VIEW / MODEL SELECT.
Move the arrow cursor with the INC or DEC buttons on SETTING AND DATA VIEW and then press ENTER
to display the parameters of the transmitter, receiver and telemetry sensors and / or program it, or select
MODEL SELECT to display the telemetry data graphically (see point 9). In MODEL SELECT display no
changes are possible.
After SETTING AND DATA VIEW have chosen, the „Lipo Cell Voltage" display is available. The sensor dis-
plays follow the transmitter (TX) and receiver (RX) displays, i.e. the „Lipo Cell Voltage" display follows after
the last display servo test (RX SERVO TEST).
Please note: the menus can only be selected when the receiver is switched on. When you switch the recei-
ver on, it may take a few seconds before the receiver display becomes active and can be selected: > symbol
appears at the top right corner of the transmitter display (TX).
There may be a slight delay in the screen's response to inputs using the top buttons, since all the settings
are transmitted directly to the receiver by wireless means.
5.1. Display LIPO CELL VOLTAGE
Please note: the labeling of the arrows of the following displays corresponds to the keys on top of the
SMART-BOX.
This
SMART-BOX
mx-12/16/20/32 HoTT
ENTER
ESC
INC
scroll: value:
DEC
scroll: value:
INC+DEC
SET
The descriptive text describes also primarily the button layout and operation of the SMART-BOX, followed by
the buttons of the mx-16 HoTT as an example in parentheses. Please note that the button layout for example
of the HoTT mc-transmitters (order No. 4758, 4759) may differ. Read the manual of your remote control
03
assignment
is
different
depending
on
mc-19/mc-22/mc-24/mx-24 HoTT
ENTER
CLEAR
scroll: push Rotary + value: Rotary
scroll: push Rotary + value: Rotary
push Rotary
33610 General Engine-Module - Graupner HoTT 2.4
the
remote
control
system.
Advertisement
Table of Contents
