Table of Contents
Advertisement
6.9. Maximum Temperature Sensor 2 (Page 10)
DEC
Ma x. S ens or 2 Te m p
>Set Warning :
page 10
Temperature :
Warning Time :
Repeat Time :
Signal Tone
:
Sensor 2
:
6.10. Maximum Current (Page 11)
DEC
Ma x. C ur r ent
page 11
>Set Warning :
Max Current :
Warning Time :
Repeat Time :
Signal Tone
:
Current
:
6.11. Maximum used Capacity (Page 12)
DEC
Ma x. U s ed C ap a c ity
>Set Warning :
page 12
2000mA
Max Capacity :
Warning Time :
Repeat Time :
Signal Tone
:
Capacity
:
6.12. Minimum Voltage socket 1 (Page 13)
DEC
Min . Po w er Vo l ta g e
>Set Warning :
page 13
Min Voltage
:
Warning Time :
Repeat Time :
Signal Tone
:
33610 General Engine-Module - Graupner HoTT 2.4
INC
The temperature of the sensor 2 (socket 7) is monitored. Warning
threshold set between -20 and 200° C (1° C steps).
100°C
Factory setting: 100° C, Signal Tone: I
Off
Always
I
00°C
INC
If the module is connected between the power supply and the motor or
receiver battery, the power consumption of the connected equipment is
40A
measured. You can program the maximum peak current at which the
Off
alarm should be triggered, to avoid to overload the motor or battery.
Always
Monitors the battery connected to port 1. The warning threshold is ad-
W
justable up to 50 A in 0.1 A steps.
0.0A
Factory setting: 40 A, Signal Tone: W
INC
If the module is connected between the power supply and the motor or
receiver battery, the power consumption of the connected equipment
is measured. You can program the max. used capacity at which the
alarm should be triggered, so you have enough remaining capacity for
Off
a save landing.
Always
Monitors the battery connected to port 1. The warning threshold is ad-
V
justable up to 30.000 mAh in 0.1 A steps.
Factory setting: 2000 mAh, Signal Tone: V
0 mA
INC
The voltage of the battery connected to socket 1 is monitored. Warning
threshold set between 0 and 80.0 V (0.1 V steps).
5.0V
Factory setting: 5.0 V, Signal Tone: P
Off
Always
A
10
Advertisement
Table of Contents
