Programming Warning Thresholds - GRAUPNER HoTT General Engine-Module 2-6 S Manual

6. PROGRAMMING WARNING THRESHOLDS

ESC
LiPo Cell Voltage
Overall volt : 11.890V
Min 8.450V Max 16.800V
1N 3.201V 2N 3.100V
3N 3.030V 4N 2.567V
5N 0.000V 6N 0.000V
Min 2.567V Max 3.201V
If you wish to carry out an adjustment, you must use the INC or DEC buttons ( or ) above the screen to
select the desired parameter (e.g. page 2) by moving the arrow cursor (INC or  moves the cursor down,
DEC oder  moves it up). Simultaneously pressing the INC and DEC (SET) buttons switches the parameter
to be adjusted to inverse video (white on black); this indicates that it can be programmed: pressing the INC
() button at this point increases the value, pressing the DEC () button reduces the value. When the ad-
justment is complete, save the selected setting by pressing the INC and DEC (SET) buttons simultaneously;
the dark background now disappears in order to confi rm this action.
Display (Set Warning): shows the various „display pages" with the possible adjustable parameters and
the associated adjustable warning thresholds (page 1, page 2, etc.). To switch between pages, press the
INC or DEC key.
Factory Set: choosing „OK", will reset the settings of the variable module to factory settings.
The following parameters can be set separately for all displays:
Warning Time: sets whether and how long the warning signal is activated when reaching a certain value
for each display screen.
Repeat Time: sets how often the warning signal is activated when reaching a certain value for each display
screen.
Signal Tone: sets the signal tone melody. The warning sounds are combined with the warnings on the
display and the voice output. Therefore, they may not be changed.
Overview of the signal tones on page 15.
When a warning is activated, the corresponding message (eg. Min. Height) is shown inverted in the
fi rst row of the associated display, which then appears alternately with the display VARIO SENSOR
and the selected Signal Tone A - Z sounds.
You can stop the warning at any time by pressing one of the buttons on the top of the SMART-
BOX.
33610 General Engine-Module - Graupner HoTT 2.4
ENTER
ENTER
>
ESC
General Engine-Module <>
>Set Warning : page 1
Save to Sensor?
Factory Set?
Ver: S 1.100
DEC
General Engine-Module <>
page 1
Set Warning :
>Save to Sensor?
Factory Set?
Ver: S 1.100
No
No
INC
No
No
06