Table of Contents
Advertisement
Parameter
Warning Time
Repeat Time
Signal Tone
Save Sensor
Factory Set
If you wish to carry out an adjustment (point 6.1 to 6.15) you must use the INC () or DEC () buttons
above the screen to select „page 1 - Save Sensor". Simultaneously pressing the INC and DEC buttons
(SET) switches the parameter to be adjusted to inverse video (white on black); this indicates that it can be
programmed: pressing the INC () button at this point increases the value to YES. When the adjustment is
complete, save the selected setting by pressing the INC and DEC buttons (SET) simultaneously; the dark
background now disappears in order to confi rm this action.
If you do not want to save the adjustments, select NO.
Warning:
•
Do not carry out any programming work on the sensors while the model is fl ying, otherwise there is a real
risk that your model will fl y out of control while you are not concentrating on it!
•
If your model is fi tted with two or more receivers, it is absolutely essential that you do not carry out pro-
gramming work during a fl ight, as this can alter the settings in the receivers to which no telemetry equip-
ment is connected; in the worst case this could result in the model crashing.
For this reason always carry out programming on the ground, and check that only the receiver with con-
nected sensors is powered on.
07
Display page
Page 2 – page 24
Page 2 – page 24
Page 2 – page 24
Page 1
Page 1
Description
Warning time
Repeat time
Signal tone
saves the setup to the General
Engine-Module
Reset to factory settings
33610 General Engine-Module - Graupner HoTT 2.4
Setup
OFF, 5, 10, 15, 20,
25, 30 sec.
Always, 1, 2, 3, 4, 5
Minuten, One Time
A - Z
OK / NO
OK / NO
Advertisement
Table of Contents
