Table of Contents
Advertisement
Parameter
BATT1 / BATT2
FUEL
E / F
T1 / T2
CELL.V
>12500<
ALT
0m|s
0m|3s
POWER-V
Multiple sensors, for example GPS and General module, can be connected to the receiver via a Y-cable
order No. 3936.11 from software version V2.x or higher for the module, receiver and SMART-BOX.
Attention: When using the Y-cable plugged into the telemetry connector on the receiver for connecting mul-
tiple sensors, only the SIMPLE DATA VIEW or MODEL SELECT can be used, because only in this mode
the sensors are addressed correctly.
The SETTING AND DATAVIEW mode for programming can not be used!
First the sensors must individually programmed, for example directly with the SMART-BOX.
10. Firmware Update GENERAL ENGINE-MODULE
Firmware updates for the General Engine-Module are transferred conjunction with a PC running Windows
XP, Vista or 7. For this you also require the USB interface, Order No. 7168.6, the adapter lead, Order No.
7168.6A and a Y-cable Order No. 3936.11 which are available separately.
The programs and fi les required for this are available from www.graupner.de in the Download area for the
corresponding products.
Install the Firmware Update Utility Graupner and the USB drivers on your computer. Check the system
requirements!
10.1. General Engine-Module
Disconnect the 3-pin lead of the General Engine-Module from the receiver. Connect the male connector of
the Y-cable in the free socket (T) of the General Engine-Module. In one female connector of the Y-cable the
adapter cable to the USB interface is plugged, into the second connector a suitable receiver battery to power
the update process is connected. Caution: Plug in the receiver battery after pushing the „Program" button
(see point 10.2), or use a switch harness.
17
Description
Battery 1 / Battery 2 (socket 5 / 7)
Fuel level / Fueltank Indicator (socket 10)
Empty / Full
Temperature of sensor 1 / sensor 2 (socket 5 / 7)
Cell Volatge of cell 1 ... max. 6 (socket 6)
Current RPM (socket 9)
Current altitude (not available)
m/1 s climb / descent (not available)
m/3 s climb / descent (not available)
•
current voltage of drive battery in V
•
electric current of drive battery in A
•
Used capacity in mAh since the start
(socket 1)
The fi rst step is to cut through the central red wire in the adapter lead, Order
No. 7168.6A, then connect the lead to the USB interface, Order No. 7168.6.
This socket is also polarised; note the small chamfer on one edge. Never use
force - the plug should engage easily and fully.
33610 General Engine-Module - Graupner HoTT 2.4
Advertisement
Table of Contents
