GRAUPNER HoTT General Engine-Module 2-6 S Manual page 19

10.2. Update procedure
Ensure that the adapter lead is confi gured as shown in the illustrations, and are connected.
Start the Graupner Firmware Update Utility.
the product (e.g. transmitter update fi le instead of receiver fi le), then the pop-up window "Product code error"
will appear, and you will not be able to start the update procedure.
Press the "Program" button in the software. Wait briefl y until you see movement in the progress bar. This
make take up to fi ve seconds, depending on the computer.
Switch on the power supply (see 10.1), so that the General Engine-Module is powered on.
After a few seconds the Status screen displays the message "Found target device..."; you can now release
the button, and the fi rmware update process commences.
If the device is not recognised, if the pop-up window "Target device ID not found" appears, or if the process
fails before 100% is reached, you must restart the update procedure. Repeat all the steps as described
above.
The Status display and the Progress bar show the progress of the fi rmware update. The update is completed
when the message "Complete...100%" or "Complete!!" appears.
Switch off the power supply and disconnect all leads from the Y-cable. Connect the General Engine-Module
with the receiver again.
33610 General Engine-Module - Graupner HoTT 2.4
Under [COM Port Setup] select the cor-
rect COM port, i.e. the one to which the
USB lead is connected. If you are not
sure of this, press the button „Search"
and select in the pop-up window „Silicon
Labs CP210x USB to UART Bridge" and
press „OK". Select Baud Rate 19200.
Under [Interface Type] click on Signal
2:Vcc 3:Gnd.
Now click on the "Browse" button and
select the folder containing the pre-
viously loaded fi rmware fi le ending in
*.bin. If everything is correct, the fi le will
appear in the corresponding window.
The fi rmware fi les are encoded in pro-
duct-specifi c form, i.e. if you acciden-
tally select a fi le which does not match
18