Advertisement
Label
10/100/1000 RJ-45 Port LEDs
The RJ-45 ports on both the Network side and Device side of the ONA have two bi-colored (amber/
green) LEDs. The one on the left side indicates the port speed and the one on the right side shows
the level of link activity.
Label
Speed
Link/Activity
Restarting the ONA
Restart the ONA by disconnecting and then reconnecting power as described below:
• If the ONA is connected to a PoE capable network switch, disconnect the Ethernet cable
connected to the RJ-45 port with the cloud symbol. Wait at least 45 seconds and then
reconnect it.
• If the ONA is connected to an external power adapter, disconnect it for at least 45 seconds and
then reconnect it.
Running diagnostics on the ONA
Use the diagnostics to verify that the ONA is operating properly.
To enter Diagnostics, use following procedure:
May 2016
Color and Status
Blue (blinking)
Off
Color and Status
Amber (steady)
Amber (blinking)
Green (steady)
Green (blinking)
Off
Amber (steady)
Amber (blinking)
Green (steady)
Green (blinking)
Green (blinking slow)
Off
Avaya Open Networking Adapter 1101GT Installation Job Aid
Description
ONA is starting
Not operational
Description
100 Mbps
N/A
1000 Mbps
N/A
10 Mbps
N/A
N/A
Blink rate indicates level of link
activity
Blink rate indicates level of link
activity
Port disabled
No Link
11
Advertisement
