Installing Fan Without Included Light Kit (Optional) - Harbor Breeze MAYFIELD BTH44AB5CS Manual

FINAL INSTALLATION
10.
Attach pull chain extensions (F) supplied in one of
the hardware packs or custom pull chain
extensions (not included) to fan and light pull
chains. (Fig. 10)

INSTALLING FAN WITHOUT INCLUDED LIGHT KIT (OPTIONAL)

1.
If you do NOT wish to use the light kit,
remove the hex nut (O) and lock washer (P)
from the threaded rod at the top of the light kit
fitter (D). Unscrew the switch housing cap to
remove it from the light kit fitter (D), and then
gently feed the BLACK and WHITE wires from
the light kit fitter (D) through the hole in the
middle of the switch housing cap. (Fig. 1)
Locate cap (K) in one of the hardware packs and
2.
place cap (K) firmly in hole in middle of switch
housing cap. Align holes in switch housing cap
with holes in switch housing. (Make sure to align
gap on top edge of the switch housing cap with
the reverse switch on switch housing for the
correct fit.) Secure switch housing cap with three
switch housing cap screws (V) that were
removed in Step 5 of "Final Installation" section
(page 11). Tighten all three switch housing cap
screws (V) securely. (Fig. 2)
10
F
1
WHITE BLACK
O
P
D
2
V
K
13
Switch
Housing
Cap
Switch
Housing
Switch
Housing
Cap