Rittal CMC III Installation Manual And Short User's Manual page 8

Installation and operation, Service
Display of the status change on the multi-LED of the Processing Unit.
– Continuous green light: All units attached to the CAN bus have the "OK" status.
EN
– Continuous orange light: At least one unit attached to the CAN bus has the "warning" status.
– Continuous red light: At least one unit attached to the CAN bus has the "alarm" status.
Display of the status change on the multi-LED of the power unit.
– Continuous blue flashing: Communication over the CAN bus.
– Green flashing: When the measured value changes or, at the latest, every 5 seconds.
If the installation is not successful: see section 1.1.
Note:
Connection cables in various lengths and other country-specific connection cables can
be obtained from Rittal.
5.3 Settings
The following parameters can be set or viewed at the CMC III PU web site:
– Voltage at the input [V]
– Frequency at the input [Hz]
– Current at the outputs [A] (separate for the two outputs)
– Effective power at the outputs [W] (separate for the two outputs)
– Consumption at the outputs [kWh] (separate for the two outputs)
– Activation or deactivation of the outputs (separate for the two outputs)
To determine whether any software updates are required: see www.rittal.com or contact Rittal Service
(see section 6).
6 Service
For technical questions, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
8 Rittal CMC III Power Unit