Turbo Mode (Automatic Transmission); Turbo Mode (Manual Transmission); Valet Mode (Via Switch) - Fortin FTX 64-2W Manual

TURBO MODE (AUTOMATIC TRANSMISSION)

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once
the driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes
allowing the turbo-charger to cool down.
To activate Turbo Mode (automatic transmission) proceed with the following steps :
STEP 1
STEP 2
STEP 3
STEP 4
WARNING :
NEVER LEAVE CHILDREN OR ANIMALS IN A REMOTE-STARTED VEHICLE UNATTENDED.

TURBO MODE (MANUAL TRANSMISSION)

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the
driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing
the turbo-charger to cool down. To activate Turbo Mode (manual transmission, see IDLE MODE
(MANUAL TRANSMISSION) on page 14.

VALET MODE (VIA SWITCH)

Valet Mode disables both the Remote-Starter and Alarm system. Whenever the vehicle is
being serviced or repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be
enabled to prevent an accidental Remote-Start.
Note : The alarm system is not active (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock and unlock the doors, and release the rear hatch/trunk.
Note : When the Remote-Starter/Alarm is in Valet Mode, the LED will stay ON solid instead of
flashing after the doors are locked. The LED will turn off only after the Remote-Starter/Alarm exit
Valet Mode.
With the engine already running, press the remote START button
until the parking lights come on. The remote Green Led flash and a
ascending melodie will sound to confirm.
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Press the LOCK button to lock the doors. The vehicle will continue
to run for 60 seconds. The remote Green Led flash and bip once
to confirm.
Page 15 / 24