Table of Contents
Advertisement
Idle mode is activated in much the same way Ready Mode is activated, except for Step 1. To activate Idle Mode
(manual transmission) proceed with the following steps:
IDLE MODE ACTIVATION:
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
The engine will continue to run until either the remote stop function is pressed (see USING THE REMOTE CONTROL,
page 3), the Remote-Starter runtime expires, the parking brake is disengaged, the brake is pressed, or the hood
is opened. If the Remote-Starter is shut down by transmitter it will automatically go in to Ready Mode (if all the doors
are closed).
WARNING : Never leave children or animals in a Remote-Started vehicle unattended.
TURBO MODE (AUTOMATIC TRANSMISSION)
Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver leaves the
vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger to cool down. To
activate Turbo Mode (automatic transmission) proceed with the following steps:
STEP 1
STEP 2
STEP 3
STEP 4
TURBO MODE (MANUAL TRANSMISSION)
Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver leaves the
vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger to cool down. To
activate Turbo Mode (manual transmission) proceed with the following steps:
See IDLE MODE (MANUAL TRANSMISSION) page 6.
V ALET MODE (VIA SWITCH) / VALET CODING
Valet Mode disables both the Remote-Starter and Alarm system. Whenever the vehicle is being serviced or repaired,
or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an accidental Remote-Start.
Open at least one door and ensure the transmission is in the NEUTRAL
position.
and
Engage the parking brake.
Release the brake pedal.
Push the START button . The parking lights will flash once and then remain
on. The remote Green Led flash and a ascending melodie will sound to
confirm.
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Lock the doors by pushing the LOCK button . The remote Green Led flash
and bip once to confirm.
With the engine already running, press the remote START button until the
parking lights come on. The remote Green Led flash and a ascending melodie
will sound to confirm.
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Press the LOCK button to lock the doors. The vehicle will continue to run for
60 seconds. The remote Green Led flash and bip once to confirm.
Page 7 / 13
Hide quick links:
Advertisement
Table of Contents
