Oracle Sun Blade X6240 Product Notes page 12

Power LED issue
The green LED Power LED incorrectly stops blinking and turns solid green once
ILOM detects that the power is good. The green Power LED should stop blinking
and turn solid only when the operating system is ready.
Disk LED issue
Due to a hardware limitation, the Blue Disk Ready-to-Remove LED will not
illuminate when executing the cfadm command.
Service LED issue
Due to a hardware limitation, the amber Service LED will not illuminate.
System hang during USB initialization
When inserting the dongle cable in to the server module, the system might hang
during universal serial bus (USB) initialization.
Workaround:
Remove and reinsert the dongle cable into the server module.
Blade server module fails to link up at 1GbE
If the Sun Blade X6240 server module is inserted into certain slots in the Sun Blade
6048 chassis, it fails to link up at 1GbE with the X5196A-Z Sun Blade 6048 Infiniband
Switched Network Express Module (NEM). This issue occurs primarily on the inner
slots (BL3-BL8). These slots can only link up at 100Mb.
Workaround:
Use the outer slots (BL0-BL2 and BL9-BL11) to link up at 1GbE.
This issue is under investigation.
10 Sun Blade X6240 Server Module Product Notes • April 2013