Garnet SeeLevel II 900-D4S Single Manual page 11

To access the Short User Code (SUC) menu (display on/off &
°F/°C selection):
1. Press and hold ENTER until "SECU COdE" appears (this will
take approximately 5 seconds).
2. Enter the 4 digit short user security code (it will be shown as
you enter it) and press ENTER. If the code is incorrect, the
gauge will exit programming mode.
3. DISPLAY ON/OFF MENU: If the code is correct the display
on/off menu will be accessed, the display will show "dISP On"
or "dISP OFF" indicating whether display is currently on or
off. Press the ↑ UP button to turn the display on, or the ↓
DOWN button to turn the display off.
4. Press ENTER to store the new display status, "Stor" will be
shown momentarily.
5. DEGREES F/C MENU: Press ↑↑ FAST UP to access the °F/°C
menu, the display will show "tEPr °F" or "tEPr °C" indicating
which mode is currently active. Press ↑ UP to select degrees
Fahrenheit or ↓ DOWN to select degrees Celsius.
6. Press ENTER to store the new temperature format, "Stor" will
be shown momentarily.
7. TANK ID MENU: Press ↑↑ FAST UP to access the Tank id
menu. This allows the tank to be given a four digit number.
The feature will be fully implemented in the future.
8. EXIT MENU: To exit the programming mode, press ↑↑ FAST
UP to access the exit menu, the display will show "SUC donE".
Press ENTER, "Prog donE" will be shown momentarily and
the gauge will return to normal operation.
9. If a menu is left without pressing ENTER, any change to that
menu item will NOT be stored. If no button is pressed for 3
minutes then the gauge will exit programming mode and any
changes which have not been stored will be ignored.
To access the Long User Code (LUC) menu (alarm point &
4-20mA calibrations):
1. Press and hold ENTER until "SECU COdE" appears (this will
take approximately 5 seconds).
2. Enter the 6 digit long user security code (it will be shown as
you enter it) and press ENTER. If the code is incorrect, the
gauge will exit programming mode.
900D4S Manual Page 11