Husqvarna 324L Workshop Manual page 7

3.2.1 To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
3.2.2 To remove and install the shaft
1. Remove the air filter cover and the engine cover.
Covers on page 15 .
Refer to
2. Disconnect the throttle cable from the carburetor.
Refer to To disconnect and connect the throttle
cable on page 20 .
3. Disconnect the short circuit cable from the ignition
module.
4. Remove the short circuit cable from the notches in
the carburetor gasket and the heat guard.
1218 - 001 - 01.07.2019
5. Remove the ground cable screw (A) and the ground
cable (B).
6. Remove the 3 screws on the flywheel housing and
disconnect the shaft.
7. Install in the opposite sequence.
A
B
Prepare and do servicing on the
product - 7