Husqvarna 324L Workshop Manual page 38
Hide thumbs
Also See for 324L:
- Operator's manual (68 pages) ,
- Operator's manual (32 pages) ,
- Operator's manual (28 pages)
Table of Contents
Advertisement
6.14.13 To install the camshaft sprocket
1. Turn the flywheel (A) until the mark (B) is aligned
with the hole (C). This is to make sure that the piston
is in its correct position.
A
C
B
2. Put the camshaft sprocket in position.
3. Make sure that the mark (A) on the camshaft
sprocket (B) points up.
A
B
38 - Repair instructions
4. Put the timing belt in position around the camshaft
sprocket and install the camshaft sprocket axle.
CAUTION: Make sure that the mark on the
flywheel and the camshaft sprocket are
aligned correctly. If the marks are not
aligned correctly, the valve timing will not be
correct. Incorrect valve timing can cause
engine failure.
6.14.14 To drain the crankcase from oil
1. Start the engine and let it run for approximately 1
minute. This is to increase the temperature of the oil
and make it drain faster.
2. Remove the oil filler cap.
3. Put the product on its side above a container with
the oil filler tube pointed down.
4. Make sure all oil is drained before you move the
product.
6.14.15 To fill the crankcase with oil
1. Put the product on a flat surface.
2. Remove the oil filler cap.
3. Fill the crankcase with oil. The oil level must be in
between the marks on the dipstick. Use the correct
Technical data on page 49 .
type of oil. Refer to
6.14.16 To disassemble the engine
To drain the
1. Drain the crankcase from oil. Refer to
crankcase from oil on page 38 .
To remove and install
2. Remove the flywheel. Refer to
the flywheel on page 28 .
To remove and install
3. Remove the muffler. Refer to
the muffler on page 24 .
To remove
4. Remove the camshaft sprocket. Refer to
the camshaft sprocket on page 37 .
To remove and
5. Remove the fuel tank. Refer to
install the fuel tank on page 30 .
To remove and
6. Remove the heat guard. Refer to
install the heat guard on page 34 .
Hide quick links:
Advertisement
Table of Contents
