Husqvarna 324L Workshop Manual page 42

7. Put the crankcase (A) in position.
B
8. Install the 6 screws (B). Tighten the screws in the
correct sequence as the illustration shows.
3
1
5
6.14.22 Standard dimensions and wear tolerances of the engine parts
Cylinder valve mechanism
Valve spring length, mm
Exhaust valve spindle diameter, Ø mm
Inlet valve spindle diameter, Ø mm
Valve guide inner diameter, Ø mm
Clearance, exhaust valve spindle / valve guide, mm
Clearance, inlet valve spindle / valve guide, mm
Camshaft sprocket inner diameter, Ø mm
Cam height, mm
Piston, crankshaft and cylinder
Piston diameter, Ø mm
42 - Repair instructions
9. Install the oil hose and the oil hose clips.
A
10. Install the heat guard. Refer to
11. Install the fuel tank. Refer to
12. Install the camshaft sprocket. Refer to
13. Install the muffler. Refer to
4
14. Install the flywheel. Refer to
15. Fill the crankcase with new oil. Refer to
2
6
Note: Screws 5 and 6 are a bit shorter than the other
screws.
the heat guard on page 34 .
the fuel tank on page 30 .
camshaft sprocket on page 38 .
muffler on page 24 .
the flywheel on page 28 .
crankcase with oil on page 38 .
Standard di-
mension
20.66
3.435-3.450
3.470-3.485
3.500-3.518
0.050-0.083
0.015-0.048
4.020-4.050
22.097
34.970-34.990
To remove and install
To remove and install
To install the
To remove and install the
To remove and install
To fill the
Wear limit
20.00
3.380
3.400
3.560
0.120
0.098
4.100
21.797
34.900
1218 - 001 - 01.07.2019